WEBVTT

00:00:00.000 --> 00:00:02.200
Replace front door decal

00:00:02.250 --> 00:00:06.150
[Side exterior of a Polestar 2 vehicle. The door decal is highlighted.]

00:00:06.200 --> 00:00:10.150
Disassembly. 1. Clean the area around the decal. Allow to dry.

00:00:10.200 --> 00:00:13.100
[Close-up of the front door decal.]

00:00:13.150 --> 00:00:22.100
Disassembly. 2. Mark the position of the old sticker by placing a piece of masking tape at the top left, left side, and bottom edge of the old sticker on the door.

00:00:22.150 --> 00:00:25.100
[Close-up of required tools. The masking tape is highlighted.]

00:00:25.150 --> 00:00:28.150
[Close-up of the decal with masking tape along its left side and bottom edge.]

00:00:28.200 --> 00:00:35.100
Disassembly. 3. Apply hot air over the sticker with a hair dryer for 30 seconds. Lift the edge of the sticker and slowly peel it off.

00:00:35.150 --> 00:00:38.100
[Close-up of required tools. The hair dryer is highlighted.]

00:00:38.150 --> 00:00:45.100
[The hair dryer is used to apply hot air over the sticker. The sticker peels off slowly.]

00:00:45.150 --> 00:00:50.150
Assembly. 1. Clean the surface with the supplied wet wipe.

00:00:50.200 --> 00:00:53.150
[Close-up of required tools. The wet wipe is highlighted.]

00:00:53.200 --> 00:00:59.100
[Close-up of the door surface. The wet wipe is used to clean it.]

00:00:59.150 --> 00:01:09.150
Assembly. 2. Remove the protective foil from the back of the decal starting on the left edge of the text. Do not peel completely in order to avoid touching the adhesive before applying.

00:01:09.200 --> 00:01:12.100
[Half of the protective foil is peeled back from the decal.]

00:01:12.150 --> 00:01:19.150
Assembly. 3. Position the door decal on the door. Use the tape applied to line up the sticker correctly.

00:01:19.200 --> 00:01:22.100
[The decal is placed on the door using the masking tape as a guide.]

00:01:22.150 --> 00:01:36.150
Assembly. 4. Use a plastic scraping tool to apply the decal slowly and carefully, beginning with the left edge of the text before going over the rest of the sticker, removing the remaining protective foil. Be careful not to scratch the paint.

00:01:36.200 --> 00:01:39.100
[Close-up of required tools. The plastic scraping tool is highlighted.]

00:01:39.150 --> 00:01:43.150
[The remaining protective foil is removed and the plastic tool moves over the decal from left to right.]

00:01:43.200 --> 00:01:50.150
Assembly. 5. Remove the top-layer assembly foil (with holes) and the masking tape. Clean the sticker assembly area on the door surface.

00:01:50.200 --> 00:01:54.100
[The top-layer assembly foil is removed from the decal.]

00:01:54.150 --> 00:01:57.100
Repeat all steps on the other side.