• Manual
  • Video gallery
  • Software updates

Manual

Exterior lighting

Active Bending Lights

Active Bending Lights (ABL) are designed to help provide extra illumination in curves and intersections.

Active high beam

Active high beams use the camera sensor at the top of the windshield. The camera sensor registers the headlights of oncoming vehicles or the taillights of vehicles ahead and automatically switches from high beams to low beams.

Using turn signals

The vehicle's turn signals are controlled using the left-side steering wheel lever. The turn signals flash three times or continuously, depending on how far up or down the lever is moved.

Brake lights

The brake lights are automatically illuminated when braking.

Rear fog light

The rear fog light is considerably brighter than the ordinary taillight and should only be used to help other road users see the vehicle when visibility is reduced by conditions such as fog, snow, smoke or dust.

Fog lights and corner illumination

The fog lights can be activated to improve visibility when driving in fog.Corner illumination switches on automatically in weak daylight or dark conditions to illuminate the area diagonally in front of the vehicle.

Low beams

When driving with the lighting ring in the position, low beam will be automatically activated in weak daylight or dark conditions.

Using high beam

High beam is operated via the left-hand steering wheel lever. High beam is the vehicle's strongest lighting and should be used when driving in dark conditions, provided it does not blind other road users, to improve visibility.

Using Guidance Light

Some of the exterior lights may remain on after the vehicle is locked in order to illuminate the area around the vehicle. This is called Guidance Light.

Emergency brake lights

The emergency brake lights are activated to warn following vehicles of hard braking. This function causes an additional taillight on each side of the vehicle to illuminate.

Parking lights

The parking lights can be used to help other road users see the vehicle if it is stopped or parked. Use the lighting ring on the steering wheel lever to turn on the parking lights.

Welcome and farewell lighting

Welcome lighting comes on when the vehicle is unlocked and farewell lighting is activated when the driver exits the vehicle.

Hazard warning flashers

Hazard warning flashers warn other road users by all of the vehicle's turn signals being activated at the same time. The function can be used to warn about a traffic hazard.

Daytime running lights

The vehicle has sensors that detect ambient lighting conditions. With the lighting ring in the position, the daytime running lights will be on. In weak daylight or dark conditions, the headlights automatically switch to low beams.